Replace Ray-Ban Meta Lenses in 60 Seconds (No Tools Needed)

Replace Your Lenses — It’s Easier Than You Think

No tools. No experience needed.

You only need to press a few points.

Step 0: Know Where to Press

Before you start, quickly locate these 3 points:

• 1 – Inner corner (near the bridge)

• 2 – Outer corner (near the hinge)

• 3 – Bottom outer corner

✔ For removal, you only press Position 2

✔ For installation, follow 1 → 2 → 3

👉 Don’t worry — you only need to press one point to remove the lens.

Step 1: Remove the Original Lens

Hold the frame from the inside.

Press firmly at Position 2 (outer corner) to push the lens outward.

Once this corner pops out, the lens will release easily.

✔ No need to force the whole lens

✔ One point is enough

Repeat for the other side.

Step 2: Get Your New Lenses Ready

Make sure you have the correct left and right lenses.

Step 3: Install the New Lens

Place the lens from the front of the frame.

Press Position 1 (inner corner) first.

Press firmly at Position 2 until it snaps in.

Finish by pressing Position 3 to fully secure the lens.

✔ Follow the order: 1 → 2 → 3

Step 4: Done

Make sure:

• No gaps

• Edges are flush

• Lens is secure

Clean the lenses — you’re ready to go.

That’s It

✔ Remove: press Position 2

✔ Install: press 1 → 2 → 3

✔ No tools needed

Quick Tips (Avoid Mistakes)

• Press one point at a time

• Do NOT twist the frame

• If it doesn’t snap in, check alignment — don’t force it